DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-302BRI-BD/LGATE-BD (ISDN-BRI Line Circuit Pack)
9
the Maintenance documentation for recommended repair procedures. The
probability of this error being related to Packet bus problems increases
with the number of ISDN-BRI circuit packs displaying this error.
If the Packet Bus is not alarmed, reset the circuit pack via the
busyout
board UUCSS
and
reset board UUCSS
commands. If the Circuit Pack
Restart Test (#594) passes, then the on-board circuitry is healthy. Retire
the alarm via the
test board UUCSS long clear
command. If the Circuit
Pack Restart Test (#594) fails, replace the circuit pack. If the problem
persists after complying with the above instructions, then follow normal
escalation procedures.
l. These errors are not service-affecting. No action is required. These errors
are reported by the circuit pack when it receives a bad control channel
message from the switch. The auxiliary data identifies the following error
events:
m. This error is not service-affecting. No action is required.
n. This error indicates that the circuit pack sent a large number of control
channel messages to the switch in a short period of time.
4096 Bad major heading
4097 Bad port number
4098 Bad data
4099 Bad sub-qualifier
4100 State inconsistency
4101 Inconsistent downlink message
3843 Bad translation RAM detected, but call continues by using
another translation location.
3999 If error type 1538 is also present, then the circuit pack was
taken out-of-service due to hyperactivity.
If error type 1538 was not present, then the circuit pack has
not been taken out-of-service, but has generated 50% of the
messages necessary to be considered hyperactive. This
may be normal during heavy traffic periods. If traffic is light it
may indicate a problem with the circuit pack or the
equipment attached to it.
