DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-363test tape
8
Output
The following display shows a typical result when
test sys-link 1e0201 current
is
entered.
test tape
test tape [C] [short | long] [repeat # | clear] [schedule]
The
test tape
command performs a series of tests on the tape circuit pack and
tape cartridge. The standard cartridge used for backups of the disk is
compatible with this test. The tape cartridge is rewound and a specific portion of
the tape is used for test reads and writes. Tapes used for core dumps have an
incompatible file system and should not be used for this test.
The cabinet is always
1
and need not be entered. Carrier
a
or
b
must be
specified only for systems with duplicated SPEs.
This command aborts if any other MSS operation has already begun.
Failure of the tape test may result in the tape being placed in an out-of-service
state. In this state, access to the tape by all system software except maintenance
is blocked.
When the host-adapter is taken out of service due to failures of its tests, or fails a
reset and becomes uninstalled, the tape is also placed in the uninstalled state
test sys-link 1e0201 current Page 1 SPE A
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
01E0201 SYS-LINK LNL 985 PASS
01A1 PKT-INT 886 PASS
01A1 PKT-INT 887 PASS
PN 01 PKT-BUS 572 PASS
PN 01 PKT-BUS 573 PASS
01E01 EXP-INTF 237 PASS
01E01 EXP-INTF 238 PASS
01E01 EXP-INTF 240 PASS
01E01 EXP-INTF 241 PASS
01E01 EXP-INTF 589 PASS
01E01 EXP-INTF 316 PASS
1 A-PNC FIBER-LK 777 PASS
1 A-PNC FIBER-LK 759 PASS
1 A-PNC FIBER-LK 237 PASS
1 A-PNC FIBER-LK 238 PASS
press CANCEL to quit -- press NEXT PAGE to continue
