DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1757TIE-TRK (Analog Tie Trunk)
9
Each tie trunk circuit pack occupies a port circuit pack slot and contains 4 port
circuits. Each port circuit supports 1 analog tie trunk used to connect the switch
to another PBX across one-way or two-way dedicated circuits (see preceding
list).
A tie trunk port can also be administered as an access endpoint which is a
non-signaling channel with a voice-grade data bandwidth. Tie trunk maintenance
employs up to 6 tests, depending on the hardware involved, to monitor the
operating condition of the trunk and its connections. These are described in the
following sections on each test. The port must be idle for these tests to run. If an
incoming call seizes the port while a test is in progress, the test aborts and the
call proceeds (except for TN497).
Additional in-line testing is performed whenever a call is in progress, logging
errors that occur during operation. You can reproduce these types of errors by
making a call over the trunk and then checking the Hardware Error Log.
By making translation and cross-connect changes, circuit packs (except for
TN497) can be configured for back-to-back testing, also known as connectivity
testing. Port operation is tested by connecting two tie trunk ports together in
either E&M or simplex modes. See the section
Analog Tie Trunk Back-to-Back
Te s t i n g
.
Error Log Entries and Test to Clear Values
Table 9-658. TIE Trunk Error Log Entries
Error
Type
Aux
Data Associated Test Alarm Level
On/Off
Board Test to Clear Value
0
1
0 Any Any Any test port
UUCSSpp
sh r 1
1(a) 16384 None WARNING OFF
1(b) 57476 None WARNING OFF
1(c) 57477 None WARNING OFF
1(d) 57483 None WARNING OFF
1(e) 57485 None WARNING OFF
15(f) Any Port Audit Update
Test (#36)
18(g) 0 busyout trunk
grp/mbr
WARNING OFF release trunk
grp/mbr
130(h) None WARNING ON test trunk
grp/mbr
257(i) 57473 None WARNING OFF
Continued on next page
