A SERVICE OF

logo

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1351PROCR (RISC Processor Circuit Pack)
9
Processor Parity Checker Test (#899)
This test verifies that the Processor can detect parity errors on the bus. If this part
of the Processor circuit pack is faulty, the system may continue to operate
properly, but may not correctly respond if a bus problem arises later. The
Processor reads a special memory location on the SYSAM circuit pack to
perform this test. Problems with the SYSAM may also cause this test to fail.
PASS The computed checksum matched the BOOTPROM checksum. This part of
the Processor will continue to operate normally.
Table 9-531. TEST #899 Processor Parity Checker Test
Error
Code
Tes t
Result Description/ Recommendation
100 ABORT The requested test did not complete within the allowable time period.
1. Retry the command.
1022
1335
2500
ABORT Internal system error
1. Retry the command.
1338 ABORT The test is not allowed to run since a planned SPE interchange is in progress.
This may be caused by a planned interchange initiated automatically during 24
hour scheduled testing.
1. Wait 3 minutes and retry the command.
1339 ABORT The test could not run on the standby Processor circuit pack in the standby SPE
carrier because the standby SPE is unavailable.
1. Refer to the STBY-SPE maintenance documentation for information on why
a standby SPE may be unavailable and what repair actions should be
taken. The screen for the status spe command should indicate that
handshake is down. This may be caused by a variety of reasons such as
the SPE-SELECT switches on the DUPINT circuit packs being set to the
position of the active SPE, a failure of the DUPINT circuit pack, or loss of
power on the standby SPE. The
SPE Selected
field on the status spe
screen will display
spe a
or
spe b
if both SPE-SELECT switches are in the a
or b positions, respectively.
Continued on next page
Table 9-530. TEST #897 Processor BOOTPROM Checksum Test — Continued
Error
Code
Te s t
Result Description/ Recommendation
Continued on next page