DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1171PDMODULE (Processor Data Module) TDMODULE (Trunk Data Module)
9
■ Bad Scan Inquiry — A message is sent uplink that contains a count
generated by certain events relating to the digital loop’s (link) conditions.
This could be an indication of communication problems between the
processor and digital port board.
■ EPF inquiry — The status of the Electronic Power Feed is sent uplink. EPF
is not used for data modules.
■ ID Request — A request is made to the data module for its status. The
data module sends its configuration information and health information
back. This information is checked and a pass/fail result is provided.
■ Ringer Update — This updates the data module’s ringer state according
to processor records.
■ Translation Update — This is a message normally used with digital
stations to refresh the default value that causes the station to send touch
tones only in the primary information channel. This test is not used with
data modules.
Table 9-466. TEST #17 Data Module Audits Test
Error
Code
Te s t
Result Description/ Recommendation
1 ABORT Switchhook audit timed out.
1. Verify the data module is connected to the PBX and repeat the test.
2. If the test aborts, replace the data module and repeat the test.
3. If the test continues to abort, replace the circuit pack and repeat the test.
2 ABORT ID request fails, health bit is defective, or no response from on-board
microprocessor.
1. Verify that the correct data module type (PDM versus TDM) is administered.
2. If the test aborts, replace the data module and repeat the test.
3. If the test aborts, replace the circuit pack and repeat the test.
3 ABORT No response from EPF audit.
4 ABORT Internal system error
1. Resolve any outstanding circuit pack maintenance problems.
2. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
