DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1479SNI-BD (SNI Circuit Pack)
9
Failure Audit (#777)
This test is non-destructive.
This test queries the SNI for any existing failures and any unacknowledged
cleared failure messages. Each failure generates an error and alarm entry
against SNI-BD, SNI-PEER, or FIBER-LK. An unacknowledged cleared failure
message is a message the SNI circuit pack sent to software indicating a previous
failure is now gone and the SNI circuit pack did not receive a message from
software indicating that the failure message was received by software.
If no failures are detected by the SNI circuit pack, this test will pass.
If this test reports failures, the results screen for the
test board
command will
show
FAIL
with no FAIL code. The error log must then be displayed via
display
errors
with category PNC to view all SNI-BD and FIBER-LK errors and category
PNC-PEER to view all SNI-PEER errors.
0NO
BOARD
No board was detected by the test.
1. Check that board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNI should be reset
instead of reseating the circuit pack. The reset board command should
almost never be used on an SNI. It may be necessary to use the reset
board command if the SNI circuit pack gets into a mode where it cannot
communicate with software. If an SNI with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore the
reset board command can mask real problems.
3. Run the test again. If it fails, the ID chip on board may be bad. Replace the
board and retest.
Table 9-565. TEST #777 Failure Audit
Error
Code
Tes t
Result Description/ Recommendation
ABORT Internal System Error
1. Retry the command at 1-minute intervals a maximum of 3 times.
Continued on next page
Table 9-564. TEST #767 Packet Neighbor Link Test — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page
