DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-261status conference
8
Endpoint Miscellaneous (EPT MISC) Information. EPT MISC contains
miscellaneous states and counters for an endpoint. The flags can be a value of y
or n. The counters start with initial value of 0x00, they increment to 0xff, and then
56/64
The
65/64
field is
derestrict
when operating at per-channel
speeds of 64kbps, 128kbps, 192kbps, 256kbps, 320kbps, 384kbps,
512kbps, 768 kbps, 1472kbps, 1536kbps, or 1920kbps; it is
restrict
when operating at 56kbps, 112kbps, 168kbps, 224kbps,
280kbps, 336kbps, 448kbps, and 672kbps.
Note that if the conference is configured for Nx56kbs operation, the
endpoint may signal either via capabilities or modes that is operating
at the proper rate. In such a case, even when we receive
derestrict
command which does not match the conference
communication mode of
restrict
, if the capability indicates
restrict
(
MISC
capability has
restrict
displayed on Page 4) the
STAT 56/64
is set to
y
to indicate 56/64 compatibility between the
conference and the endpoint.
VIDEO
The Video mode:
H.261
(recommended),
H.CTX
(proprietary),
H.CTX
+ (proprietary), or
SG4
(proprietary) indicate that video is on in
the direction indicated;
video-off
when the video is off.
MLP
Multi Layer Protocol data mode. When
Data Mode
is administered as
any-mlp
or
ww-pcs
, the MLP mode should be
var-MLP
. Other
values will affect video status.
The
MLP
mode should be
MLP-off
when Data Mode is administered
as
none
. Again, other values in this mode will affect video status.
H_MLP
The High Speed MLP mode. The HMLP mode should be
H-MLP-off
.
Other values in this mode will affect video status.
LSD
Low Speed Data mode. The LSD mode should be
LSD-off
. Other
values in this mode will affect video status.
HSD
High Speed Data mode. The HSD mode should be
HSD-off
. Other
values in this mode will affect video status.
CRYPT
Encryption mode. The CRYPT mode should be
encrypt-off
. Other
values in this mode will affect video status.
S/M
Single/Multi channel interoperability mode.
6B-H0-comp
indicates
that the sender is interoperating multiple channels and a single
channel (for example, 6B and H0).
Not-comp-6B-H0
indicates that
the sender is not interoperating between 6B and H0. Normally this
value is Not-comp-6B-H0. Other values in this mode will affect video
status.
