DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-888GPTD-PT (General Purpose Tone Detector Port)
9
Technician-Demand Tests: Descriptions and Error
Codes
Always investigate tests in the order presented below when inspecting errors in
the system. By clearing error codes associated with the
Tone Detection
Verification Test,
for example, you may also clear errors generated from other
tests in the testing sequence.
Tone Detection Verification Test (#42)
This test verifies that the call progress tones detection and the tone level
measurement capabilities of the GPTD port are functioning properly.
Order of Investigation
Short Test
Sequence
Long Test
Sequence D/ND
1
1. D = Destructive; ND = Nondestructive
Tone Detection Verification Test (#42) X X ND
Tone Detector Audit/Update Test (#43) X X ND
Table 9-338. TEST #42 Tone Detection Verification Test
Error
Code
Tes t
Result Description/ Recommendation
ABORT The system was not able to allocate all the resources needed for this test or
there was an Internal system error.
1 ABORT The system could not allocate all the resources needed to test the call progress
tones.
1001 ABORT The system was unable to put the GPTD port in the appropriate mode to test it.
1002 ABORT The system could not allocate time slots for the test connection. This can
happen when the system is heavily loaded. If the system is not heavily loaded,
then test the TDM-BUS via the test tdm [1|2] command.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
