DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-200save translation
8
Examples
save translation disk
save translation either tape
Output
Results are displayed for each SPE.
The following display shows a typical result of entering
save translation
on a
duplex system.
active
This specifies saving translation data on the active SPE only.
standby
This specifies saving translation data on the standby SPE only.
both
This specifies saving translation data on both SPEs concurrently (the default).
The command will fail if the specified device on either SPE is inaccessible,
and neither device will be saved to.
either
This specifies saving translation data on both SPEs. If the standby is
inaccessible, the save will still be done on the active SPE.
disk
This specifies saving translation data to the disk drive. Disk is the default
device.
tape
This specifies saving translation data to the tape drive.
Processor
This identifies the SPE to which translation data was saved (SPE-A or
SPE-B).
Command
Completion
Status
One of the following results is displayed:
Success
Disk device is out of service
Tape device is out of service
save translation
SAVE TRANSLATION
Processor Command Completion Status
SPE-A Success
SPE-A Success
Command Successfully Completed
