DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1517STO-DATA (Stored Data)
9
Backing Up Data: MSS Commands
Several commands are available for copying files from system memory to the
MSS, and for copying files from one MSS device to another. They are
summarized in the following table. Refer to Chapter 8, for complete descriptions
and additional options for these commands.
The following commands are not used in normal backup or maintenance
procedures. They are sometimes useful in special situations such as software
updates or resolving specific file inconsistencies between devices.
Table 9-574. Mass Storage System Commands
Command
Execution
Time * Action/Remarks
save translation
[disk]
1
1. Execution times vary; those shown are expected maximums. Entries in brackets ([]) are defaults and
need not be entered. Pipes (|) indicate a choice between options.
2 minutes Copy translation from system memory to disk File is
timestamped at time of command.
save announcement 40 minutes Copy announcement file from TN750 to disk File is
timestamped at time of command. Use after recording
announcements.
restore announcement 40 minutes Copy announcement file from disk back to TN750 Use
after a TN750 or announcement administration error.
backup disk
[incremental]
20-50
minutes
Copy from disk to tape all files on disk that are newer
Done to both SPEs if duplicated
backup disk full 50 minutes Copy all disk files to tape Done to both SPEs if duplicated
Use after replacing tape cartridge.
restore disk [full] 50 minutes Copy all tape files to disk Use after disk is replaced. Done
to both SPEs if duplicated.
copy announcement
tape
2 minutes Copy announcement file from disk to tape Keeps
timestamps consistent.
copy update-file tape 2 minutes Copy update file from disk to tape Keeps timestamps
consistent.
