DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1256PKT-INT (Packet Interface Circuit Pack)
9
may be necessary to force the standby SPE to go active by using the
SPE-SELECT switches on the DUPINT circuit packs to run the
Maintenance Looparound test to make sure the problem is cleared.
For more information, refer to the repair procedures of Test #886.
m. Error 1025 indicates a failure of the private Level 3 looparound test (Test #
885).
1. If the Packet Interface circuit has a MAJOR alarm:
a. Reset the Packet Interface circuit pack using the
reset
packet-interface CS
command.
b. Refer to the repair procedures for the
Packet Interface Reset
Test (#889)
.
2. If the Packet Interface circuit pack is not alarmed, no action is
required.
n. Error 1281 indicates that the Packet Interface circuit pack has Translation
RAM failures. PKT-INT Translation RAM is used to convert the addresses
of a packet to the destination endpoint address.
1. If the Packet Interface circuit has a MAJOR alarm:
a. Reset the Packet Interface circuit pack using the
reset
packet-interface CS
command.
b. Refer to the repair procedures for the
Packet Interface Reset
Test (#889)
.
2. If the Packet Interface circuit pack is not alarmed, no action is
required.
o. Error 1537 indicates a Boot PROM memory failure. The Packet Interface
circuit pack may still be operational if no other errors are reported.
However the circuit pack may report a fatal fault during board initialization.
This may occur during a system recovery level more severe than a WARM
restart. For more information, refer to Test #884.
p. Error 1793 indicates a FLASH Memory test failure. The Packet Interface
circuit pack may still be operational if no other errors are reported.
However the circuit pack may report a fatal fault during board initialization.
This may occur during a system recovery level more severe than a WARM
restart. For more information, refer to the repair procedures of Test #884.
q. Error 2049 indicates a LAPD Received Buffer Overflow error. The Packet
Interface circuit pack Packet bus receive buffer overflowed. For more
information, refer to the repair procedures of Test #887.
r. Error 2305 indicates a Packet Bus Interface Detected Parity failure. The
Packet Interface circuit pack received packets with parity error from the
Packet bus.
1. Check for errors logged against the Packet bus and
Maintenance/Test circuit pack. Refer to the appropriate repair
procedures to clear those errors first.
