DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1560SW-CTL (Switch Control)
9
interchange. In that case, Error Types 2 and 150 will be entered in the error log
for the Switch Control on the standby SPE, indicating that a failure of the Switch
Control Transmission Test caused a spontaneous SPE interchange. Refer to the
Error Log information presented earlier in this repair document for the
procedures to clear problems associated with a SW-CTL error log entry of 2.
Table 9-593. TEST #94 Control Channel Transmission Test
Error
Code
Tes t
Result Description/ Recommendation
0 ABORT The port circuit packs necessary for this test are not available. For this test to
pass, it must receive a successful response to a circuit pack query message
from at least one of the following circuit pack types in the PPN cabinet:
Tone/Clock circuit pack (TN768 or TN780) Tone Detector circuit pack (TN599)
1. Retry the command at 1-minute intervals a maximum of 5 retries.
2. If the test keeps aborting with this abort code, replace the MSSNET circuit
pack.
3. If the test keeps aborting with this abort code, verify that the PPN has at
least one of the circuit packs listed above.
1335 ABORT Internal System Error. The MSSNET circuit pack is on the standby SPE and this
test is not allowed to execute on a MSSNET circuit pack on the standby SPE.
1. If this abort code is received for a Switch Control on a standby SPE in a
system equipped with the High Reliability or Critical Reliability configuration,
there must be a software error. Test #94 is not allowed to run on a standby
Switch Control.
2. Retry the command at 1-minute intervals, a maximum of 5 times.
1338 ABORT The test is not allowed to run since a planned SPE interchange is in progress.
This may be caused by a planned interchange initiated automatically during 24
hour scheduled testing.
1. Wait 3 minutes and retry the command.
2012
2500
ABORT Internal System Error
1. Retry the command.
2013
2100
none
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 3 retries.
Continued on next page
