DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-690DS1 CONV-BD
9
Board Options Audit (#795)
This test is non-destructive.
This test sends the administered circuit pack options to the DS1 CONV circuit
pack. Options are sent to both DS1 CONV circuit packs at the same time to
prevent any transitional mismatch of options.
The following data is sent to the TN574 DS1 CONV circuit pack: system reliability
configuration, master and slave end-points for framing (this is determined by the
relative position of the circuit pack to the SPE), the facility mask (if each facility is
installed), clock reference mask (whether each facility can be used as a clock
reference source and whether the board is being used as a Network Timing
Source), packet compatible mask (whether each facility is packet compatible)
and facility information for line coding, framing mode, and line compensation.
The following data is sent to the TN1654 DS1 CONV circuit pack: system
reliability configuration, master and slave end-points for framing (this is
determined by the relative position of the circuit pack to the SPE), the facility
mask (whether each facility is installed), idle code, CRC enabled/disabled flag
(sent in E1 mode only) and facility information for line coding and line
compensation (sent in T1 mode only).
0NO
BOARD
The system software found no board.
1. Reset the board.
2. Remotely retry the command.
Table 9-266. TEST #790 DS1 Facilities Connectivity Loopback Test — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page
