DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-99ANN-BD (Announcement Circuit Pack)
9
5. To delete an announcement, press 3, and confirmation tone will be given if
the delete was successful.
Saving and Restoring Announcements
Integrated announcements on the announcement circuit pack can be uploaded
to the system tape or disk with the
save announcements
command. Likewise,
integrated announcements can be downloaded to the announcement circuit
pack with the
restore announcements
command. Both commands require a
free system port, an announcement data module administered on the
announcement circuit pack and, if saving to tape, a non-write protected tape
cartridge in the tape drive. Typical announcement uploads or downloads take 30
to 45 minutes, depending on system traffic.
The system automatically attempts to download to the announcement circuit
pack 5 minutes after it is inserted. This automatic download procedure may be
aborted or preempted by any of the following:
■ An announcement is recorded within 10 minutes of circuit pack insertion.
■ An announcement download is invoked sooner with the
restore
announcements
command.
■ An announcement data module is not administered or is busy.
■ A system access port is not available.
■ There is no tape is in the system when saving to tape.
■ The tape or disk does not have a valid announcement file.
NOTE:
If the announcement file becomes corrupted, the only solution is to
re-record all announcements.
!
WARNING:
All alarms are upgraded to MAJOR when the BASE Tone Generator is set to
12. (France).
