DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-196save announcements
8
save announcements
!
CAUTION:
Do not execute
save announcements
if there is an unresolved problem
with the HOST-ADAPTR maintenance object. Save translations should not
be done to a tape or disk device with unresolved problems. Doing so may
destroy a good copy of the files.
!
CAUTION:
The option to save announcements to only one SPE in a duplicated system
should be used with care since it causes two inconsistent versions to exist
in storage.
!
CAUTION:
The save command can take up to 40 minutes to complete. Avoid pressing
ENTER
during this time since doing so will cause the result messages to be
lost.
The save announcements command copies announcement data from the
TN750B Integrated Announcement circuit pack to the Mass Storage System
(MSS). Default devices are the disk in a disk/tape system, and the devices in
both SPEs in a duplicated system. Other options are available as described
below.
Save announcements
writes two identical copies of the announcement data to
each specified device. Each copy bears the same time-stamp, (the time at which
the first copy was written). Each copy is also marked with the state of the copy
(“good” or “bad”).
Execution of this command requires the presence of a TN750B circuit pack and
an administered announcement data module and associated system port.
The command is disallowed or aborts if:
■ An announcement data module and system port data module are not
administered.
■ The announcement data module port is out of service or already in use.
■ No announcements are on the board.
■ An integrated announcements session is in progress.
■ The board is currently being uploaded or downloaded.
save announcements [active | standby | spe-a | spe-b | both | either]
[disk | tape]
