DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-515DIG-LINE (Digital Line)
9
Digital Station Audits Test (#17)
This is a series of six tests that are classified as audits. The SPE sends messages
to the on-board microprocessor to perform the following tests. These audits run
only if the station is in-service.
■ Switchhook Inquiry Test — This is an update of the SPE records according
to the circuit pack’s records. This inquiry is sent all the way to the voice
terminal.
■ Bad Scan Inquiry Test — A message is sent uplink which contains a count
that is generated due to certain events relating to the link conditions. This
can be an indication of communications problems between the Processor
and Digital Port circuit pack.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use display port UUCSSpp to determine the station extension or
attendant number of the port. Use status station or status attendant to
determine the service state of the port. If the port is in use, wait until the
port is idle before testing. Attendants are always in use (off-hook) if the
handset is plugged in and the port is not busied out.
2. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1392 ABORT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either the display port command
(the display shows that the port is a TTI port) or the list config command
(the display shows a “t” for the port).
2. If either list config or display port indicates that the port is
not
a TTI port,
escalate the problem. If both commands indicate that the port is a TTI port,
the abort is correct, and no action is necessary.
FAIL Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS The message to light all of the station lamps was sent successfully to the port.
1. Observe the station lamps being lit when running the test. If all lamps do
not light, the other Digital Line test results may indicate related problems
that do not allow the lamps to light.
2. Investigate by using other Digital Line port tests, and by examining the
station, wiring, and connections.
Table 9-210. TEST #16 DIG-LINE Station Lamp Updates Test — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page
