DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-353test memory
8
The following display shows a typical result when
test mass-storage a
is
entered.
test memory
test memory CSS [short | long] [repeat # | clear] [schedule]
This command performs hardware diagnostic tests on any or all Memory circuit
packs in the specified carrier. All tests in both sequences are non-destructive.
The short test takes about 2 minutes to complete. The long test on a single circuit
pack takes about 2.5 minutes. The long test takes an additional 2 minutes on
circuit pack 1 for the Checksum Test.
Parameters
Output
NOT ASSIGNED indicates that the specified slot is not administered.
CSS The cabinet is always 1 and need not be specified. Carrier a or b must be
specified only for duplicated SPEs. You can specify one of the Memory circuit
pack slots (1-4) on the PPN control carrier. If the slot is not specified, all
memory circuit packs are tested.
test mass-storage
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
01A H-ADAPTR 822 PASS
01A H-ADAPTR 823 PASS
01A H-ADAPTR 824 PASS
01A H-ADAPTR 825 PASS
01A TAPE 809 PASS
01A TAPE 812 PASS
01A TAPE 813 PASS
01A TAPE 814 PASS
01A TAPE 815 PASS
01A DISK 809 PASS
01A DISK 812 PASS
01A DISK 813 PASS
01A DISK 814 PASS
01A DISK 815 PASS
Command Successfully Completed
