DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-75display alarms
8
Output
After valid options are entered by the technician, an alarm report is displayed.
The data displayed on this form will be:
Port
The location of the alarmed object. For installed circuit packs, the
location is displayed as
cabinet-carrier-[slot]-[circuit]
. For Port
Network-related objects, the location is displayed as
PN UUB
, where
“UU” is the Port Network number and B is the bus (A or B). For Fiber
Link-related objects, the location is displayed as
x a-PNC
where “x” is
the Fiber Link number and “a” is the PNC side (A or B). This is the
same identifier as used by the alarm log.
Maintenance
Name
The logical name of the MO which has been alarmed.
On Brd
Whether the fault detected is on the associated circuit pack, or an off
board element connected to the circuit pack.
Alt Name
The alternate means of identifying the MO. This field contains the
extension when the object is a station, and it contains xxx/yyy when the
object is a trunk, where xxx is the trunk group number and yyy is the
member number. It contains P/xxx when the object is a private CO line,
where xxx is the private CO line group number.
Alarm Type
MAJOR, MINOR, or WARNING. This is an indicator to the seriousness
of the alarm raised.
Service
State
RDY (ready for service), OUT (out of service), or IN (in service). This is
the current service state of the station and trunk ports shown. If a blank
is displayed in this field it means that no service state is associated
with the MO.
Ack?
The columns under the “1” and “2” headings denote if the alarm has
been acknowledged by the first and second OSS telephone numbers,
respectively. A “y” in this field means that the alarm has been
acknowledged. An “n” means that the alarm has not been
acknowledged. A “c” means that the alarm resolved and cleared and
the alarm notification was acknowledged. A blank means that there will
be no attempt to report the alarm.
Date
Alarmed
Day, hour, and minute of alarm.
Date
Resolved
Day, hour, and minute of resolution. For active alarms this field is zero
(0).
