DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1591SYS-LINK (System Links)
9
3. When all the components are alarm free, wait for 3 minutes to allow the
links to recover.
4. Test the system link (
test sys-link PCSSpp long clear
) and notice any
tests that fail.
5. If there are any failures, fix the problems indicated by the tests and repeat
the procedure.
Error Log Entries and Test to Clear Values
Notes:
a. This error indicates that the link went down. The link may have gone down
or never come up. Enter command status sys-link location
and check
the value of the
Faulted Path
field. If the value is
default
, then the link
never came up. If the value is
present
, then the link came up and then
went down.
1. Follow the information in the ‘‘Common Procedure for Repairing
Link Problems’’ section above.
2. Wait for 3-5 min. before checking the link state.
3. Repeat the procedure until there are no problems with the
components.
b. This error indicates that the link has experienced uplink flow control.
Manifest effect of this error is that the end-point may be hyperactive. The
system link is alarmed if 4 or more errors of this type are detected within
10 min.
Table 9-599. Maintenance Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
13 (a) System Link Status
(985)
MINOR/
WARNING
OFF
257 (b) WARNING OFF test sys-link UUCSSpp l cl
513 (c) WARNING OFF test sys-link UUCSSpp l cl
772 (d) WARNING OFF test sys-link UUCSSpp l cl
1025 (e) WARNING OFF test sys-link UUCSSpp l cl
1281 (f) WARNING OFF test sys-link UUCSSpp l cl
1537 (g) WARNING OFF test sys-link UUCSSpp l cl
1793 (h) WARNING OFF test sys-link UUCSSpp l cl
