DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1647TAPE
9
1338 ABORT Could not run the test on the Standby SPE—Interchange pending.
1. Refer to the documentation for STBY-SPE maintenance.
2. After interchange occurs, run test on new active SPE.
1339 ABORT Could not run the test on the Standby SPE—Handshake down.
1. Refer to the documentation for STBY-SPE maintenance.
2. When standby is restored to service (use status spe to determine state of
standby) retry command.
1347 ABORT Could not run the test on the Standby SPE—Refresh not complete.
1. When standby is restored to service (use status spe to determine state of
standby) retry command.
1350 ABORT Could not run the test on the Standby SPE—Shadowing not enabled.
1. When standby is restored to service (use status spe to determine state of
standby) retry command.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
5102 ABORT Could not allocate the Mass Storage System to run this test
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, verify that the daily translation-save
operation is not in progress (issue the display system-parameters
maintenance command to display the time for scheduled maintenance
and the "y/n" option for saving translation daily).
NO
BOARD
The tape has been placed in the "uninstalled" state.
1. Verify that a tape cartridge is installed and not write-protected and that the
tape drive is fully inserted and powered up.
2. Attempt a demand reset of the tape.
Table 9-620. TEST #812 Tape Firmware Error Counters Read
and Clear Test — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page
