DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1628SYSTEM (System)
9
Notes for SYSTEM Error 605 AUX Data:
1. Follow repair instructions in “STBY-SPE” for the particular standby SPE
problem. After fixing that problem, try the interchange again.
2. Mass Storage System is in use. Check Disk and Tape LEDs for activity.
Wait until all MSS activity completes, then retry the interchange again. If
the problem persists, check for alarms and errors against MSS
components and follow the repair procedures for the “MSS” maintenance
object.
3. Test the PKT-INT on both carriers with the long test sequence. Follow
procedures for “PKT-INT”. Once
all
tests of both PKT-INTs pass, try the
interchange again.
4. Consult SW-CTL service documentation. Test SW-CTL on both carriers
with the long test sequence. Follow repair instructions for any failures.
Once
all
tests of both SW-CTLs pass, try the interchange again.
5. Make sure the standby SPE is refreshed, then try the interchange again.
6. Examine alarm log to determine which of the PKT-INT or SYSAM circuit
packs has a minor alarm against it. Consult the section in this chapter for
that circuit pack.
7. Check for errors or alarms against active SPE’s SYSAM. If you find any,
consult SYSAM service documentation. If you find none, and if all tests of
the SYSAM long sequence pass, try the interchange again.
8. Run test duplication-interface long and follow instructions for any test
that does not pass.
1396 3 PKT-INT Link Migration failure in Begin Step *
1397 3 PKT-INT Link Migration denied, (peer test in progress)
1398 3 PKT-INT Link Migration failure in Completion Step *
1399 3 PKT-INT Link Migration failure in Finish Step *
1400 4 Could Not Idle SW-CTL dual port RAM *
1401 4 Could Not Refresh SW-CTL dual port RAM *
1402 5 Internal Error (could not get duplication status)
1403 5 Unable to inhibit Standby Maintenance Monitor
1404 5 Failure to determine Standby SPE alarm status
1406 3 Active SPE’s PKT-INT in held-reset state
1418 8 Active Duplication Interface circuit pack is in a bad state and
needs to be reset.
2500 5 Internal Software failure (* sometimes)
Table 9-615. SYSTEM Error 605 AUX Data, Failure of Planned Interchange
