DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1626SYSTEM (System)
9
g. A
reset system interchange health-override
command has failed. The
standby SPE state-of-health (SOH) would not allow a spontaneous SPE
interchange. Use
status spe
to determine the current SPE status and
follow the Standby SPE Maintenance procedures to resolve the problems
that are preventing the SPE interchange.
h. A requested SPE interchange has failed because the SPEs are locked by
means of the SPE-Select switches on the duplication interface circuit
packs. with the SYSAM lock switches.
i. Error 6001 indicates that an operating system error occurred on the active
SPE. The aux data gives the source of the error:
j. Error 6002 indicates that an application error occurred on the active SPE.
See note (o) to diagnose the error using the aux data.
k. Error 6003 indicates that an application alarm occurred on the active SPE.
See note (o) to diagnose the error using the aux data.
l. Error 6100 indicates that an operating system error occurred on the
standby SPE. See error 6001 (i) to interpret the aux data.
m. Error 6102 indicates that an application error occurred on the standby
SPE. See note (o) to diagnose the error using the aux data.
n. Error 6103 indicates that an application alarm occurred on the standby
SPE. See note (o) to diagnose the error using the aux data.
Aux-Data Value Operating System Error Type
5 Software Abort
6 SPE Bus Error
