DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-730DUP-CHL (Duplication Interface)
9
12. If the SPE Standby State-of-Health is functional as observed with the
status spe
command, use the
reset system interchange
command. With
the other SPE now active, execute the
busyout spe-standby
command
and use the
test duplication-interface long clear
command to test the
Duplication Channel in the other direction, resolving any outstanding
alarms against DUPINT and DUP-CHL.
■ If these tests pass, continue with step 13.
13. Execute the
release spe-standby
command and wait for memory
shadowing and standby refreshed to complete as verified with the
status
spe
command.
■ If the standby is not refreshed within 10 minutes, continue with step
14.
■ If the standby is refreshed within 10 minutes, this replacement
procedure is successfully finished.
14. Use the
status spe
command. If the status shows MAJOR alarms, use the
display alarms
command with the
spe
category selection. Resolve
alarms for maintenance objects other than DUPINT and DUP-CHL.
■ If the standby is not refreshed within 10 minutes, or the DUPINT and
DUP-CHL alarms are not resolved, escalate the problem.
■ If the standby is refreshed within 10 minutes, and the DUPINT and
DUP-CHL alarms are resolved, this replacement procedure is
successfully finished.
