DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-362test sys-link
8
Parameters
test sys-link
test sys-link UUCSSpp [channel # ] [current | faulted]
[short | long][repeat # | clear] [schedule]
The
test sys-link
command will validate the existence of the specified link and
run diagnostic tests on the hardware path that comprises the system link. If the
“current” or “faulted” option is specified, tests are run on all hardware objects
that comprise the specified link. If “current” or “faulted” is not specified, only the
end-to-end sys-link connection will be tested.
The hardware path that comprises a system link consists of up to 21 hardware
components that affect the behavior of the link. The number of components of a
given system link hardware path depends on the system configuration and type
of system link. The following links are examples of system links: Expansion
Archangel Links (EAL), Indirect Neighbor Links (INL), Processor Gate Control
links (PGC), PRI signaling links (PRI), System Access Port links (SAP), X.25
adjunct links (X25).
Parameters
Examples
test sys-link 2e0201 current l schedule
test sys-link 2e0201 faulted r 10
test sys-link 1c1701 channel 3 r 10
long
Both long and short sequences run Test #417. If Stratum 3 synchronization is
administered, an additional non-destructive test (#649) is run by the long
sequence.
UUCSSpp
The location of the port associated with the system link.
channel
number
The processor channel (1 to 128) associated with an X.25 adjunct link to
be tested.
current
This specifies testing of the current hardware path of the system link.
faulted
This specifies testing of the hardware path of the system link as it was
constituted when a fault last caused the link to go down. For more
information, see ‘‘Common Input Parameters’’
at the beginning of this
chapter.
