DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-368upgrade software
8
As the command progresses, results of each step are displayed with
corresponding error codes. The entire process takes about 10 minutes. While the
system is saving translations the following progress message is displayed and
updated every 10 seconds:
Maximum remaining translation save time: 03 mins 20 secs
A success or failure result is displayed. If the following message appears, system
software is corrupted; follow normal escalation procedures.
Error encountered; can’t complete request
Simplex SPE
The following display shows a typical result when
upgrade software
is executed
on a system with a simplex SPE.
Upgrade
Step
Each step in the upgrade execution is displayed after it occurs:
1. disable maintenance: This step prevents periodic maintenance
from interfering with the upgrade (similar to the
disable all
command).
2. save translation: Saves a copy of the current translation to the
primary MSS device
3. reboot processor: Reboots the processor, causing a temporary
service outage.
4. If the upgrade is successful,
Command successfully
completed is
not
displayed. Instead, the terminal is logged off the
system and must be logged in again.
Results This displays whether the step was successful or not. Possible values
are: PASS, FAIL, or SKIPPED. SKIPPED only occurs for the save
translation step when the current version is newer than the version on
the primary MSS device, causing this step to be bypassed.
Error Code If a step fails, this field displays a code indicating the reason. See the
following table.
upgrade software
UPGRADE RESULTS
Upgrade Step Results Error Code
disable maintenance PASS
save translation PASS
reboot processor PASS
