DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-10Common Abort and Fail Codes
8
Common Abort and Fail Codes
Table 8-3 lists common error codes associated with abort and fail results for
busyout, release, test, and reset commands. In addition to these, many
maintenance objects have other unique error codes.
Table 8-3. Common Error Codes for Busyout, Release, Test,
and Reset Commands
Error
Code
Command
Result Description/Recommendation
ABORT System resources are unavailable to run command.
1. Try the command again at 1-minute intervals up to 5 times.
0 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT A DS1 interface circuit pack could not be reset because it is
currently supplying the on-line synchronization reference.
1. Use the
set sync
command to designate a new DS1
interface circuit pack as the on-line reference, then try the
reset again.
1010 ABORT Attempt was made to busyout an object that was already busied
out.
1011 ABORT Attempt was made to release an object that was not first busied
out.
1015 ABORT A reset of this circuit pack requires that all maintenance objects
on it be in the out-of-service state.
1. Use the
busyout board
command to place all objects on the
circuit pack in the out-of-service state, and try the reset
again.
1026 ABORT The specified TDM bus cannot be busied out because the
control channel or system tones are being carried on it. You can
use the
set tdm PC
command to switch the control channel and
system tones to the other TDM bus.
1030 ABORT This command is not allowed on a circuit pack on the standby
SPE.
Continued on next page
