DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-762ERR-LOG (Error Log)
9
ERR-LOG (Error Log)
The ERR-LOG maintenance object (MO) is responsible for the sanity of the Alarm
Log, the Hardware Error Log, and the Software Error Log. If an inconsistency is
detected in any one of these logs, all logs will be re-initialized and a hardware
error will be logged against ERR-LOG indicating the time of inconsistency. There
are no tests and no alarms for the Error Log MO. This MO exists solely for the
purpose of allowing errors to be logged against it.
Hardware Error Log Entries
Notes:
a. Indicates that an inconsistency was detected in either the Alarm Log, the
Hardware Error Log, or the Software Error Log. The system attempts to
recover the logs but, depending on the extent of the corruption, some or
all entries in the logs may be lost. Any alarms that were active at the time
of this error have been cleared. There is no associated test for this error.
The Aux Data value indicates when the inconsistency was found:
MO Name (in
Alarm Log) Alarm Level Initial Command to Run Full Name of MO
ERR-LOG none none Error Log
Error
Type Aux Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
510 (a) See below none none none none
0 During a periodic audit of the Error Log
1 After an extended reboot
2 After a reboot
4 After a Level-3 System Reset (COLD_1)
8 After a Level-2 System Reset (COLD_2)
16 After a Level-1 System Reset (Warm Start)
100 After an internal software audit
2500 After a single-process (MDM) restart
