DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-506DIG-LINE (Digital Line)
9
and generates no Error Log entries or alarms. To begin the test, Maintenance will
ask call processing to make the associated endpoint and port “ Maintenance
Busy”. This test succeeds if the endpoint is "idle". If the reserve request fails then
the test aborts. If the request succeeds then the SPE sends a message to loop
around both information channels for the digital terminal. First the primary
information (voice, Information Channel 1 or I1) channel loopback test is run. The
test is performed by sending a digital count from the Tone/Clock circuit pack on
the primary information channel time slot and receiving the same digital count
with a general purpose tone detector.
If the primary information channel test is successful, the loop around test for the
secondary information (data, Information Channel 2 or I2) channel is then
performed. This test is the same as the primary information channel loop around
test and is performed only if a DTDM is administered. This is also the case for a
linked DA.
Only one value (Pass. Fail, or Abort) is generated as a result of the two tests run.
If any test fails aborts, the sequence is stopped. Upon completion of this test the
associated endpoint and port are moved back into the previous service state.
Table 9-206. TEST #1201 Digital Terminal Remote Looparound Test
Error
Code
Tes t
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
extension or attendant number of the port. Use status station or status
attendant to determine the service state of the port. If the port is in use,
wait until the port is idle before testing. Attendants are always in use
(off-hook) if the handset is plugged in and the port is not busied out.
2. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1001 ABORT System resources required to run this test are not available.
1. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
