DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Commands
8-195resume hardware-group
8
The following display shows a typical result when
restore disk
is entered.
resume hardware-group
resume hardware-group
In the course of execution of a
test hardware-group
command, it may be
desirable to halt the test temporarily or permanently. This is accomplished by
either the
cancel hardware-group
command for a background test, or by
pressing
Cancel for a foreground test.
Resume hardware-group
enables you to
restart the hardware group test at the point where it was canceled. This capability
is not available if another hardware group test has been started. The status of a
hardware group test can be obtained with
status hardware-group
.
When
test hardware-group all-ports
is canceled, the internally generated port
translations for previously untranslated ports are removed. If
resume
hardware-group
is then entered, only customer-administered ports will then be
tested.
resume
does
not
reinstate the port translations that were removed by
cancellation of the test.
Output
When a test that was executing in the background is resumed, a success
message is displayed. When a test that was executing in the foreground is
resumed, test results are displayed.
restore disk
RESTORE DISK
Processor Command Completion Status
SPE-A Success
SPE-B Success
Command Successfully Completed
