DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1258PKT-INT (Packet Interface Circuit Pack)
9
w. Error 3585 indicates that a Packet bus failure has been detected and that
the Packet bus is alarmed. Refer to the Packet Bus maintenance
documentation for further action.
x. Error 3841 indicates that the Packet Interface circuit pack has reported a
fatal fault failure condition that may be caused by a Packet Bus failure on
the Processor Port Network.
1. If error 3585 has also been reported, refer to the maintenance
documentation for PKT (Packet Bus) maintenance. After the Packet
Bus failure has been corrected, execute the
reset packet-interface
command to bring the Packet Interface circuit back into service.
2. If error 3585 has not been reported, enter the
reset
packet-interface
command and follow the repair steps associated
with test #889.
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below. By clearing
error codes associated with the
Packet Interface Private Looparound
test for
example, you may also clear errors generated from other tests in the testing
sequence.
Notes:
a. This test is run only on a Packet Interface circuit pack on an active SPE.
b. This test is run only on a Packet Interface circuit pack on a standby SPE.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
1. D = Destructive; ND = Nondestructive
Packet Interface Reset Test (#889) X D
Packet Interface Private Looparound Tests
(#885)
XND
Packet Interface Maintenance Looparound
Test (#886) (a)
XX ND
Packet Interface Memory Checksum Test
(#884)
XND
Packet Interface Error Counter Read and
Clear Test (#887)
XX ND
Packet Interface Active-Standby Peer Link
Test (#888) (b)
XX ND
