DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-481DID-DS1 (Direct Inward Dial Trunk)
9
Port Audit and Update Test (#36)
This test sends port level translation data from the switch processor to the DS1
Interface circuit pack to assure that the trunk’s translation is correct. The port
audit operation verifies the consistency of the current state of the trunk as kept in
the DS1 Interface circuit pack and in the switch software.
0NO
BOARD
The test could not relate the internal ID to the port. This could be due to
incorrect translations, no board is inserted, an incorrect board is inserted, or
an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the lIst config
command and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, issue the busyout
board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the link
between the internal ID and the port. If not, check to see that there is a
valid board inserted.
Table 9-198. TEST #36 Port Audit and Update Test
Error
Code
Tes t
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT The port may be busy with a valid call.
1. Issue display port UUCSSpp to determine the trunk group/member
number of the port. Use the status trunk command to determine the
service state of the port. If the port is in use, wait until the port is idle
before testing.
2. If the port status is active but the port is not in use (no calls), check the
error log for error type 1025. The port may be locked up.
3. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
Continued on next page
Table 9-197. TEST #7 Conference Circuit Test — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page
