DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-174ATM-EI (Expansion Interface Circuit Pack)
9
■ The fiber between the ATM switch and the ATM-EI is too long
(greater than 2km for multimode fiber). Use loopback to see if the
fiber is corrupting the cells.
■ Some other ATM-EI board is not receiving the cells properly.
■ The intervening ATM switch is dropping the ATM cells due to a
shortage of bandwidth, or the DEFINITY is using more than the
subscribed bandwidth.
Error Type 771: the ATM switch is sending cells with unknown VPI and VCI
address (wrong connection).
1. Ensure that the ATM-EI board address on the ATM switch matches
the ATM-EI (ATM) address on the DEFINITY side.
i. Error Type 1024-1151: These errors represent problems detected by the
ATM-EI board in response to SETUP and ADDPARTY requests from
software.
■ The Error Types and descriptions are in Table 9-75:
■ Aux Data values represent port network and angel numbers and
are in Table 9-76
.
Table 9-75. ATM Error Types 1024 - 1151
Error
Type Description General problem
1024 Next node unreachable
ATM protocol stack on
ATM-EI circuit pack
1056 DTL Transit not my node ID
Continued on next page
