DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1914VC-DSPPT
9
Error Log Entries and Test to Clear Values
Notes:
a. This port has been busied out by the
busyout port UUCSSpp
command.
b. The VC DSP Port NPE Crosstalk Test(#1103) failed.
c. The VC DSP Port Local TDM Loopback Test(#1104) failed. Run the Long
Test Sequence.
d. A critical hardware failure has been detected on the circuit pack. Reset
the port by the
busyout port UUCSSpp
and
reset port UUCSSpp
commands. If the VC Reset DSP Test (#1106) passes, then the on-board
circuitry is healthy. Retire the alarm with the
test port UUCSSpp long
clear
command.
e. The VC DSP port reported loss of framing on the Service Channel between
the VC and MMI circuit packs.
f. The VC DSP Port DSP Loopback Test (#1105) failed.
g. The DSP corresponding to this port on the VC circuit pack reported a
firmware error. No action is required.
Table 9-706. VC-DSPPT Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/ Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If all test pass, run the long test sequence. Refer to the appropriate
test description and follow the recommended procedures.
0 Any Any Any test port UUCSSpp sh r 1
18 (a) 0 busyout port UUCSSpp WNG OFF release port UUCSSpp
257 (b) Any NPE Crosstalk Test (#6) MIN ON test port UUCSSpp 1 r 3
513 (c) Any VC DSP Port Local TDM
Loopback Test (#1104)
MIN ON test port UUCSSpp sh r 3
778 to
781 (d)
Any VC Port Reset DSP Test
(#1106)
MAJ ON See note (d)
1025 (e) WNG ON
1281 (f) Any VC DSP Port DSP
Loopback Test #(1105)
MIN ON test port UUCSSpp sh r 3
3840 (g)
