NetWare Configuration
41
3
O
Press the
{
ESC
}
key until “Exit?” appears, and select
[
Yes
]
to exit PCON-
SOLE.
P
Turn the printer power off and on.
Note
❒
To confirm that the printer is configured correctly, type as follows from the
command prompt.
F:> USERLIST
❒
If the printer works as configured, the name of the print server appears as
an attached user.
NetWare 4.x - Advanced Settings
This section describes how to configure your printer to use as a print server in
the NetWare 4.x environment.
Preparation
The following procedures use the Property Sheet method in configuring the
Network Interface Board. If you configure the Network Interface Board as a
NetWare print server for the first time, we recommend you use the Wizard
method. For more information, see P.36 “Quick Setup Using the NIB Setup Tool
Wizard”.
Note
❒
This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.
❒
You should install the client software released from Novell on the Windows
before running the NIB Setup Tool for configuring in NDS mode or using
Windows NT 4.0.
Basic Procedure
Installing the NIB Setup Tool
Configuring the Network Interface Board
Configuring the NetWare
Turning the power off and on
