19
3. Configuring the Printer for
the Network
This section describes how to configure your printer for use as a network printer.
The actual procedures may differ depending on your network environment. Use
the appropriate procedures for your network environment.
If you use TCP/IP protocol to print, the printer must also be configured to use
TCP/IP protocol. Follow the instructions in "Setting Up the IP Parameters" sec-
tion of this manual to configure your printer to use TCP/IP protocol. After that,
go to the section with instructions for the type of network you use.
If you use protocols other than TCP/IP, go to the section with instructions for
the type of network you use.
The network configuration page is automatically printed when the printer is
turned on. This feature can be disabled with the MAP utility or by connecting
the Network Interface Board address with a browser. To disable this feature,
open the
[
Network Setting
]
screen. Then click
[
Configure Status Page
]
and remove
the check mark from
[
Print Status Page on Startup
]
.
The network configuration page contains the Network Interface Board status in-
formation. You need this information when you configure the printer for the net-
work.
Reference
Netware ⇒ P.36 “NetWare Configuration”
Macintosh ⇒ P.48 “Macintosh Configuration”
