Error & Status Messages on the Operation Panel
101
9
Note
❒
If you cannot solve the problem by taking the actions listed in the preceding
table, turn the printer power off and then back on again. If this does not clear
the error message, take a note of the contents and number of the error mes-
sage and contact your sales or service representative.
Remove Paper:
Shift Tray
The shift tray of the Finisher
SR730 is full.
Remove paper from the shift
tray.
Remove Paper:
Standard Tray
The standard output tray is
full.
Remove paper from the output
tray.
Remove Paper:
Staple Tray
There is paper in the stack
unit of the finisher.
Remove paper from the stack
unit of the finisher.
Replace Toner The toner bottle is empty. Replace the old toner bottle with
a new one.
⇒
P.127 “Replacing the
Toner Bottle”
Reset Fusing
Unit Correctly
There is no fusing unit, or
the fusing unit is not in-
stalled properly.
Install the fusing unit properly.
For more information on the fus-
ing unit, see the "Maintenance Kit
Type 4500 Replacement Guide"
that comes with the maintenance
kit.
Reset Tray #
Correctly
There is no paper tray, or
Tray # is not set correctly.
Set the tray correctly.
Messages Description Comments
