NetWare Configuration
39
3
Setting Up as Print Server
A
Log in to the file server as a Supervisor or a Supervisor equivalent.
B
Run the NIB Setup Tool.
Reference
⇒ P.25 “Running the NIB Setup Tool”
C
Click
[
Property Sheet
]
and click
[
OK
]
.
The
[
Browse
]
dialog box of the Network Interface Board appears.
D
Click
[
IPX protocol
]
.
E
Select the IPX address of the Network Interface Board which is to be con-
figured by clicking it, and then click
[
Next >
]
.
Note
❒
If you do not know which Network Interface Board you are configuring,
see the network configuration page to confirm the MAC address (Network
Address).
F
Confirm that the MAC address and IPX address are correct, and click
[
Fin-
ish
]
.
The
[
NIB Setup Tool
]
window appears.
G
Click
[
Configure
]
.
The property sheet appears.
H
Click the
[
General
]
tab, and type the name of the print server into the
[
Device
Name
]
box.
I
Click the
[
NetWare
]
tab, and make the following settings.
A
Select
[
Bindery
]
.
B
In the
[
File Server Name:
]
box, type the name of the file server in which a
print server is to be created.
Click
[
Browse
]
to select a file server among those listed in the
[
Browse
]
dia-
log box.
C
Click
[
OK
]
to close the property sheet.
D
After a confirmation dialog box appears, click
[
OK
]
.
J
On the
[
NIB
]
menu, click
[
Exit
]
to exit the NIB Setup Tool.
K
Type “PCONSOLE” from the command prompt.
F:> PCONSOLE
