Configuring the Printer for the Network
38
3
O
If you have selected the NDS mode, type the volume of the print queue into
the
[
Queue Volume
]
box.
Clicking
[
Browse
]
, you can select one of those shown in the
[
Browse
]
dialog
box.
P
Click
[
Next >
]
.
A dialog box to confirm the printing environment appears.
Q
After confirming the environment, click
[
Next >
]
.
If you want to change the settings, click
[
< Back
]
and make the settings again.
Clicking
[
Next >
]
, the NIB Setup Tool automatically creates the Print Server,
the Printer, and the Print Queue in the NetWare network.
R
After a confirmation dialog box appears, select
[
Quit
]
and click
[
Finish
]
to
exit the NIB Setup Tool.
NetWare 3.x - Advanced Settings
This section describes how to configure your printer to use as a print server in
the NetWare 3.x environment.
Preparation
The following procedures use the Property Sheet method in configuring the
Network Interface Board. If you configure the Network Interface Board as a
NetWare print server for the first time, we recommend you use the Wizard
method. For more information, see P.36 “Quick Setup Using the NIB Setup Tool
Wizard”.
Note
❒
This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.
Basic Procedure
Installing the NIB Setup Tool
Configuring the Network Interface Board
Configuring the NetWare
Turning the power off and on
