Installing the Memory Unit
15
2
D
Remove the two screws locking
the printer board.
You need the screws to lock the
printer board afterwards.
E
Hold the handle, and carefully
pull out the printer board.
F
Confirm that the notch on the
memory unit is on the right as
shown in the illustration. Tilting
the memory unit with the notch
on the right, slide it into the slot
as shown in the illustration (
A
).
Then, move it upward until it
clicks into place (
B
).
G
Align the printer board with the
top and bottom rails in the print-
er, and then insert the printer
board slowly until it clicks into
place.
H
Lock the printer board with the
two screws you removed in step
D
.
I
Return the cover to its original po-
sition with the four screws you re-
moved in step
C
.
Note
❒
Print a configuration page to
confirm that the memory unit is
properly installed. ⇒ P.144
“Printing the Test Page”
TAPP600E
TAPP610E
TAPP622E
TAPP630E
TAPP750E
TAPP590E
