Troubleshooting
106
9
Operation panel error mes-
sage stays on after removing
the misfed paper.
Open the front cover of your printer and then close it.
Be sure to close the lower vertical paper feed cover.
⇒
P.108 “Removing Misfed Paper”
Desired tray isn't used for the
output.
Check the paper size settings. The size specified with
the paper size dial might be different from the actual
paper size. Make the correct dial setting.
⇒
P.93 “Load-
ing Paper and Other Media”
When you are using a Windows operating system, the
printer driver settings overrides those specified using
the operation panel. Specify the desired output tray us-
ing the printer driver. See the driver's online help file.
The printed image is differ-
ent from the image in the
computer.
When you use some features such as enlargement and
reduction, the layout of the image might be different
from those shown in the computer display. Before
printing, use the print preview to see how the page will
look when printed. If necessary, adjust the settings.
It takes too much time to re-
sume printing.
The data is so large or complex that it takes time to pro-
cess it. If the
Data In
indicator is blinking, the data pro-
cessing is being done. Just wait until it resumes.
Energy Saver mode might be enabled. In Energy Saver
mode, it takes time for the machine to warm up.
⇒
P.129 “Using the Operation Panel”
Image is printed in the
wrong orientation.
Specify the correct orientation under the “PCL Menu”
with the operation panel.
⇒
P.129 “Using the Operation
Panel”
Part of the image cannot be
printed.
A paper size which is smaller than those specified in
the application is used for printing. Load the correct
size of paper. If you can't select the paper size specified
in the application, make use of the zooming features.
See the driver's online help file.
Network configurations you
have made do not become ef-
fective.
Turn the printer power off and on. The network config-
uration page of the Network Interface Board will be
printed automatically. Check the configuration of the
Network Interface Board with this page.
The output from the Finisher
SR730 is curled and a paper
misfeed has occurred with
the Finisher SR730.
A paper misfeed may have occured because of curled
paper in the output tray. If the paper output is curled,
remove the paper from the paper tray and load it again
after turning it over.
The print resolution of the
printed image is lower than
what you set.
The memory installed on the printer is insufficient. In-
crease the printer's memory.
Status Possible Causes, Descriptions, and Solutions
