Faxing
28
2
B Place the original.
Note
r You can scan a few pages of
your original from the exposure
glass and the remaining pages
from the ADF. When you have
finished scanning from the ex-
posure glass, remove the origi-
nal from the exposure glass and
place the remaining pages in the
ADF within ten seconds.
r To send two or more pages us-
ing the exposure glass, set them
one page at a time.
r The original can be placed
whenever, before the {Start} key
is pressed.
Reference
p.13 “Placing Originals”
C Select the scan settings you re-
quire.
Reference
p.31 “Scan Settings”
D Dial a destination.
Note
r If you make a mistake, press the
{Clear/Stop} key, and then enter
the correct number.
Reference
p.36 “Specifying a Destination”
p.47 “Chain Dial”, Facsimile Ref-
erence <Advanced Features>
p.47 “Redial”, Facsimile Refer-
ence <Advanced Features>
E Press the {Start} key.
Note
r Do not lift the ADF during scan-
ning.
After transmission, the standby
display appears.
-Sending originals using the
exposure glass
A Make sure that Immed. TX is se-
lected. If it is not, press [Immed. TX].
B Place the first page face down on
the exposure glass.
C Dial a destination.
D Make the scan settings you re-
quire.
E Press the {Start} key.
