Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
94
-
Rule ID : 22 Ports: 1-7
Match on
VLAN ID : 8 Mask : 0xFFF
Source MAC : 00-01-02-03-04-05 Mask : FF-FF-FF-FF-FF-FF
Destination MAC :00-05-04-03-02-00 Mask : FF-FF-FF-FF-FF-00
Action:
Deny
DES-3200-28/ME:admin#
The following example displays the packet content mask profile for the profile with an ID of 4:
DES-3200-28/ME:admin#show access_profile profile_id 4
Command: show access_profile profile_id 4
Access Profile Table
Profile ID: 4 Profile name:4 Type: User Defined
MASK on
offset_chunk_1 : 3 value : 0x0000FFFF
offset_chunk_2 : 5 value : 0x0000FF00
offset_chunk_3 : 14 value : 0xFFFF0000
offset_chunk_4 : 16 value : 0xFF000000
Available HW Entries : 255
-------------------------------------------------------------------------------
-
Rule ID : 1 Ports: 1-2
Match on
offset_chunk_1 : 3 value : 0x000086DD
offset_chunk_2 : 5 value : 0x00003A00
offset_chunk_3 : 14 value : 0x86000000
Action:
Deny
DES-3200-28/ME:admin#
6-5 config flow_meter
Description
This command is used to configure the flow-based metering function. The metering function
supports three modes: single rate two color, single rate three color, and two rate three color. The
access rule must be created before the parameters of this function can be applied.
For the single rate two color mode, users may set the preferred bandwidth for this rule, in Kbps,
and once the bandwidth has been exceeded, overflowing packets will either be dropped or have a
drop precedence set, depending on the user configuration.