Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
345
Chapter 37
Link Layer Discovery
Protocol (LLDP) Command
List
enable lldp
disable lldp
config lldp [message_tx_interval <sec 5-32768> | message_tx_hold_multiplier <int 2-10> |
tx_delay <sec 1-8192> | reinit_delay <sec 1-10>]
config lldp notification_interval <sec 5-3600>
config lldp ports [<portlist> | all] [notification [enable | disable] | admin_status [tx_only | rx_only |
tx_and_rx | disable] | mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable] | basic_tlvs
[{all} | {port_description | system_name | system_description | system_capabilities}] [enable |
disable] | dot1_tlv_pvid [enable| disable] | dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] |
vlanid <vidlist> ][enable | disable] | dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid
<vidlist> ] [enable | disable] | dot1_tlv_protocol_identity [all | {eapol | lacp | gvrp | stp }][enable
| disable] | dot3_tlvs [{all} | {mac_phy_configuration_status | link_aggregation |
power_via_mdi|maximum_frame_size}][enable | disable]]
config lldp forward_message [enable | disable]
show lldp
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
show lldp ports {<portlist>}
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports {<portlist>}
37-1 enable lldp
Description
This command is used to globally enable the LLDP function.
When this function is enabled, the Switch can start to transmit LLDP packets and receive and
process the LLDP packets. The specific function of each port will depend on the per-port LLDP
setting.
For the advertisement of LLDP packets, the Switch announces the information to its neighbor
through ports. For the receiving of LLDP packets, the Switch will learn the information from the
LLDP packets advertised from the neighbor in the neighbor table. The default state for LLDP is
disabled.
Format
enable lldp
Parameters
None.