Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
630
Appendix A
Password Recovery
Procedure
This chapter describes the procedure for resetting passwords on D-Link switches. Authenticating
any user who tries to access networks is necessary and important. The basic authentication
method used to accept qualified users is through a local login, utilizing a Username and Password.
Sometimes, passwords get forgotten or destroyed, so network administrators need to reset these
passwords. This chapter explains how the Password Recovery feature can help network
administrators reach this goal.
The following steps explain how to use the Password Recovery feature on D-Link devices to easily
recover passwords.
Complete these steps to reset the password:
1. For security reasons, the Password Recovery feature requires the user to physically
access the device. Therefore this feature is only applicable when there is a direct
connection to the console port of the device. It is necessary for the user needs to attach a
terminal or PC with terminal emulation to the console port of the Switch.
2. Power on the Switch. After the ‘Starting runtime image’ message, the Switch will allow 2
seconds for the user to press the hotkey [^] (Shift + 6) to enter the “Password Recovery
Mode.” Once the Switch enters the “Password Recovery Mode,” all ports on the Switch
will be disabled and all port LEDs will be lit.
Boot Procedure V4.04.004
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : 00-01-02-03-04-00
H/W Version : C1
Please Wait, Loading V4.04.004K Runtime Image .............. 100 %
UART init ................................................. 100 %
Starting runtime image
Password Recovery Mode
>
3. In the “Password Recovery Mode” only the following commands can be used.
Command Parameters
reset config
{force_agree}
The reset config command resets the whole configuration back to the
default values. If force_agree is specified, the configuration will reset to
default without the user’s agreement.
reboot
The reboot command exits the Reset Password Recovery Mode and
restarts the Switch. A confirmation message will be displayed to allow the
user to save the current settings.