Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
235
DES-3200-28/ME:admin#config erps log enable
Command: config erps log enable
Success.
DES-3200-28/ME:admin#
25-7 config erps trap
Description
This command is used to configure trap state of ERPS events.
Format
config erps trap [enable | disable]
Parameters
trap - Specify to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.
disable - Enter disable to disable the trap state. The default value is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the trap state of the ERPS:
DES-3200-28/ME:admin#config erps trap enable
Command: config erps trap enable
Success.
DES-3200-28/ME:admin#
25-8 show erps
Description
This command is used to display ERPS configuration and operation information.
The port state of the ring port may be as "Forwarding", "Blocking", "Signal Fail". "Forwarding"
indicates that traffic is able to be forwarded. "Blocking" indicates that traffic is blocked by ERPS
and a signal failure is not detected on the port. "Signal Fail" indicates that a signal failure is
detected on the port and traffic is blocked by ERPS.
The RPL owner administrative state could be configured to "Enabled" or "Disabled". But the RPL
owner operational state may be different from the RPL owner administrative state, for example, the
RPL owner conflict occurs. "Active" is used to indicate that the RPL owner administrative state is
enabled and the device is operated as the active RPL owner. "Inactive" is used to indicate that the
RPL owner administrative state is enabled, but the device is operated as the inactive RPL owner.