Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
52
Parameters
<server_index 1-3> - Specify to delete a RADIUS server.Enter the RADIUS server index.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a radius server:
DES-3200-28/ME:admin#config radius delete 1
Command: config radius delete 1
Success.
DES-3200-28/ME:admin#
4-23 config radius
Description
This command is used to configure a RADIUS server.
Format
config radius <server_index 1-3> {ipaddress <server_ip> | key <password 32> | auth_port
[<udp_port_number 1-65535> | default] | acct_port [<udp_port_number 1-65535 > | default ] |
timeout [<sec 1-255> | default] | retransmit [<int 1-20> | default]}
Parameters
<server_index 1-3> - Enter the RADIUS server index here. This value must be between 1 and 3.
ipaddress - (Optional) The IP address of the RADIUS server.
<server_ip> - Enter the RADIUS server IP address here.
key - (Optional) The key pre-negotiated between switch and RADIUS server. It is used to encrypt
user’s authentication data before being transmitted over internet. The maximum length of the
key is 32.
<password 32> - Enter the key here. The key can be up to 32 characters long.
auth_port - (Optional) Specify the UDP port number which is used to transmit RADIUS
authentication data between the Switch and the RADIUS server. The range is 1 to 65535. The
default value is 1812.
<udp_port_number 1-65535> - Enter the authentication port number here. This value must
be between 1 and 65535.
default - Specify that the default port number will be used.
acct_port - (Optional) Specify the UDP port number which is used to transmit RADIUS
accounting statistics between the Switch and the RADIUS server. The range is 1 to 65535.
The default value is 1813.
<udp_port_number 1-65535> - Enter the accounting port number here. This value must be
between 1 and 65535.
default - Specify that the default port number will be used.
timeout - (Optional) The time in second for waiting server reply. The default value is 5 seconds.
<sec 1-255> - Enter the timeout value here. This value must be between 1 and 255 seconds.
default - Specify that the default timeout value will be used.