Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
581
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable |
disable]}
Parameters
<index> - Enter the host index value here.
all - Specify that all the host indexes will be used.
severity - (Optional) Specify the severity level.
emergency - Severity level 0
alert - Severity level 1
critical - Severity level 2
error - Severity level 3
warning - Severity level 4
notice - Severity level 5
informational - Severity level 6
debug - Severity level 7
<level 0-7> - Enter the severity level value here. This value must be between 0 and 7.
facility - (Optional) Some of the operating system daemons and processes have been assigned
Facility values. Processes and daemons that have not been explicitly assigned a Facility may
use any of the "local use" facilities or they may use the "user-level" Facility. Those Facilities
that have been designated are shown below. This facility setting will be put in the syslog
packet when it is sent to a specific syslog server.
local0 - Specify that the user-defined facility will be set to local 0.
local1 - Specify that the user-defined facility will be set to local 1.
local2 - Specify that the user-defined facility will be set to local 2.
local3 - Specify that the user-defined facility will be set to local 3.
local4 - Specify that the user-defined facility will be set to local 4.
local5 - Specify that the user-defined facility will be set to local 5.
local6 - Specify that the user-defined facility will be set to local 6.
local7 - Specify that the user-defined facility will be set to local 7.
udp_port - (Optional) Specify the UDP port number.
<udp_port_number> - Enter the UDP port number used here.
ipaddress - (Optional) Specify IP address for the host.
<ipaddr> - Enter the IP address used for the configuration here.
state - (Optional) The syslog protocol is used for the transmission of event notification messages
across networks to a host. The option enables or disables the host to receive such messages.
enable - Specify that the host to receive such messages will be enabled.
disable - Specify that the host to receive such messages will be disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the syslog host configuration:
DES-3200-28/ME:admin#config syslog host all severity debug facility local0
Command: config syslog host all severity debug facility local0
Success.
DES-3200-28/ME:admin#