Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
579
66-6 show syslog
Description
This command is used to display the syslog protocol global state.
Format
show syslog
Parameters
None.
Restrictions
None.
Example
To display the syslog protocol global state:
DES-3200-28/ME:admin#show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3200-28/ME:admin#
66-7 create syslog host
Description
This command is used to create a new syslog host. The user can choose and report specific levels
of messages to a specific host. When the user chooses a specific level for a specific host,
messages which are at that severity level or higher will be reported to that host.
Format
create syslog host <index 1-4> ipaddress <ipaddr> {severity [emergency | alert | critical |
error | warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state [enable |
disable]}
Parameters
<index 1-4> - Enter the host index value here.
ipaddress - Specify the IP address for the host.
<ipaddr> - Specify the IP address for the host.
severity - (Optional) Specify the severity level.
emergency - Severity level 0
alert - Severity level 1
critical - Severity level 2