Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
350
eapol - (Optional) Specify that the EAPOL protocol will be advertised.
lacp - (Optional) Specify that the LACP protocol will be advertised.
gvrp - (Optional) Specify that the GVRP protocol will be advertised.
stp - (Optional) Specify that the STP protocol will be advertised.
enable - Specify that the protocol identity TLV according to the protocol specified will be
adverstised.
disable - Specify that the protocol identity TLV according to the protocol specified will not be
adverstised.
dot3_tlvs - Specify that the IEEE 802.3 specific TLV data type will be configured.
all - (Optional) Specify that all the IEEE 802.3 specific TLV data type will be used.
mac_phy_configuration_status - (Optional) This TLV optional data type indicates that LLDP
agent should transmit 'MAC/PHY configuration/status TLV'. This type indicates it is
possible for two ends of an IEEE 802.3 link to be configured with different duplex and/or
speed settings and still establish some limited network connectivity. More precisely, the
information includes whether the port supported the auto-negotiation function, whether the
function is enabled, the auto-negotiated advertised capability, and the operational MAU
type. The default state is disabled.
link_aggregation - (Optional) This TLV optional data type indicates that LLDP agent should
transmit 'Link Aggregation TLV'. This type indicates the current link aggregation status of
IEEE 802.3 MACs. More precisely, the information should include whether the port is
capable of doing link aggregation, whether the port is aggregated in a aggregated link, and
the aggregated port ID. The default state is disabled.
power_via_mdi - (Optional) This TLV optional data type indicates that LLDP agent should
transmit 'Power via MDI TLV'. Three IEEE 802.3 PMD implementations (10BASE-T,
100BASE-TX, and 1000BASE-T) allow power to be supplied over the link for connected
non-powered systems. The Power Via MDI TLV allows network management to advertise
and discover the MDI power support capabilities of the sending IEEE 802.3 LAN station.
The default state is disabled.
maximum_frame_size - (Optional) This TLV optional data type indicates that LLDP agent
should transmit 'Maximum-frame-size TLV. The default state is disabled.
enable - Specify that the IEEE 802.3 specific TLV data type selected will be advertised.
disable - Specify that the IEEE 802.3 specific TLV data type selected will be not advertised.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable SNMP notifications from port 1-5:
DES-3200-28/ME:admin#config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
DES-3200-28/ME:admin#
To configure port 1-5 to transmit and receive:
DES-3200-28/ME:admin#config lldp ports 1-5 admin_status tx_and_rx
Command: config lldp ports 1-5 admin_status tx_and_rx
Success.
DES-3200-28/ME:admin#