Filter
Top Products
xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
183
Chapter 18
Debug Software Command
List
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show error_reboot state
debug show status {module <module_list>}
18-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - (Optional) Specify the IPv4 address of the TFTP server.
<path_filename 64> - (Optional) The pathname specifies the DOS pathname on the TFTP
server. It can be a relative pathname or an absolute pathname. This value can be up to 64
characters long.
Restrictions
Only Administrator-level users can issue this command.
Example
To dump the error log: